I'm very excited after performing trial runs on our demo gantry system at office.
It all started off with the urgency to complete off the programming of the gantry system, destined for the Automation Expo, happening at Mumbai this 23rd.
With Parker's MotionMax 9000 front end, ACR 9640 Controller, Compax3 Servo Drives, SMB Servo Motors, PS series Gear Heads, EL series Belt actuators and ETH series Ball Screw actuators, the demo gantry was a full fledged system, depicting the breadth of Parker Products. This MotionMax 9000 is a GUI between the ACR Controller and PC. It has the ability to convert .NC files to direct motion, and that's the best part!
Here is a sample which I had developed for the expo...
It all started off with the urgency to complete off the programming of the gantry system, destined for the Automation Expo, happening at Mumbai this 23rd.
With Parker's MotionMax 9000 front end, ACR 9640 Controller, Compax3 Servo Drives, SMB Servo Motors, PS series Gear Heads, EL series Belt actuators and ETH series Ball Screw actuators, the demo gantry was a full fledged system, depicting the breadth of Parker Products. This MotionMax 9000 is a GUI between the ACR Controller and PC. It has the ability to convert .NC files to direct motion, and that's the best part!
Here is a sample which I had developed for the expo...
